mikuni Posted October 10, 2013 Share Posted October 10, 2013 Success! Very rarely do people photoshop a car and then actually make it better than the PS 1 Quote Link to comment Share on other sites More sharing options...
Truenotch Posted October 10, 2013 Share Posted October 10, 2013 Just do a skid and you'll stop caring about the paint on the wheels . 2 Quote Link to comment Share on other sites More sharing options...
kpr Posted October 10, 2013 Author Share Posted October 10, 2013 ^ this will happen 1 Quote Link to comment Share on other sites More sharing options...
kpr Posted November 22, 2013 Author Share Posted November 22, 2013 get out of my shed silly corona e36 steering rack in. everywhere seemed to say the steering shaft was too short. but this one was strangly too long? no problems though, as the there was enough spline to make it fit! some manipulating the ps lines and they also fit. once together properly will go back out in the sun, for the rest to the clearcoat to fall off. 3 Quote Link to comment Share on other sites More sharing options...
NicT Posted November 25, 2013 Share Posted November 25, 2013 That model corona has all the bad ideas from a crown, shoved in a chassis that is smaller and more difficult to wield a large hammer under to get crap out like springs. You should turbo this for maximum lols, i even see a turbo on ur floor u can use Quote Link to comment Share on other sites More sharing options...
kpr Posted November 25, 2013 Author Share Posted November 25, 2013 hmm that turbo does seem to be inching it way towards the car. Quote Link to comment Share on other sites More sharing options...
d.p.n.s Posted November 25, 2013 Share Posted November 25, 2013 just reminds me of this beater 4 Quote Link to comment Share on other sites More sharing options...
kpr Posted November 25, 2013 Author Share Posted November 25, 2013 haha, that does some good skids! Quote Link to comment Share on other sites More sharing options...
Rookie Posted November 25, 2013 Share Posted November 25, 2013 Have you looked at aliexpress for parts for these? I'm pretty sure I found a stainless Turbo manifold for $75 haha Quote Link to comment Share on other sites More sharing options...
kpr Posted November 25, 2013 Author Share Posted November 25, 2013 This is finest german engineering, not going to put any chinese junk on it. http://www.aliexpress.com/item/TURBO-MANIFOLD-E30-88-91-M20-I6-T3-Flange-Stainless-Steel-Turbo-Manifold/770081803.html mean 3 Quote Link to comment Share on other sites More sharing options...
kpr Posted November 26, 2013 Author Share Posted November 26, 2013 took day off to get some stuff done on the starlet. did i few things on this junk also. steering rack is a success, belt on fluid in. seems to work sweet. it pretty much turns lock to lock now. wide body spec front guards. cable tied the lip back together. almost ready for a test run. it chassis out on that small lip into the shed! 6 Quote Link to comment Share on other sites More sharing options...
nothingsfree Posted December 1, 2013 Share Posted December 1, 2013 Proud of you. 1 Quote Link to comment Share on other sites More sharing options...
kpr Posted December 29, 2013 Author Share Posted December 29, 2013 Any one want to give me a big wad of cash and live the dream of the fine german engineered drift car? before it goes back in the paddock. took it to a drift day a month or so back at meremere. was bit of a dissapointment. key points being so so gutless. - to the point i had to straight line the whole drift section to get enough speed to do the entery very very slow to rev handled pretty weird, wheel tramp E-brake worked mean. Could be good with some cash/ time throwen on it. (4age turbo) but stock suspension and paddock sounds like more fun. Quote Link to comment Share on other sites More sharing options...
bigfoot Posted December 29, 2013 Share Posted December 29, 2013 I got offered 1 of these for cheap, so tempted lol Quote Link to comment Share on other sites More sharing options...
kpr Posted December 29, 2013 Author Share Posted December 29, 2013 Too late. stock suspension is back in the rear, stock + 45mm lift in front underway. come at me long grass, maybe the closest i get to living my dream of driving through a corn feild. took a couple of pics before i pulled it apart Quote Link to comment Share on other sites More sharing options...
kpr Posted December 31, 2013 Author Share Posted December 31, 2013 dat angle.. 7 Quote Link to comment Share on other sites More sharing options...
thegreatestben Posted December 31, 2013 Share Posted December 31, 2013 And the crowd goes Moo Quote Link to comment Share on other sites More sharing options...
pusherman Posted January 1, 2014 Share Posted January 1, 2014 Nice car (cow)pat your self on the back sir Quote Link to comment Share on other sites More sharing options...
kpr Posted January 2, 2014 Author Share Posted January 2, 2014 cows just ain't (car)ing. also Wtb: more grass. Quote Link to comment Share on other sites More sharing options...
glen Posted January 2, 2014 Share Posted January 2, 2014 you know you want to. 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.