bigfoot

Mk4 and mk 5 are pretty much the same anyway

Gave the engine bay a quick clean and swapped the crossmember for one that wasn't bashed up by the road and the painted, unbent one fitted

Engine has been getting more and more tired lately, and started smoking/running rough yesterday, so last night and this morning I did this

Its been a busy few months Did some driving Bought a 2nd hand engine with the intention of giving it a rebuild and found this: the previous owner said the engine had been sitting outside under a tarp for 6 months. The rust cleaned up beautifully with a hone and there was no other signs of bhg Short block assembled and painted red to make it go faster Engine ready to go. With shiney rocker cover and manifold courtesy of @Mr Vapour making the rest of my engine look shit

I might be freeish this sunday, depending on how engine swap on the daily goes. Next weekend is out for me cos I'm working at v8 taxis

I have stuff for @Shakotom

Is the fuel pump putting out too much pressure for the reg to bleed off? Saw that on the internet once

As far as I know, all the input shafts are the same. Tail housings and output shafts are different. I will test that theory tomorow night, I have one of each box in my shed

2 options then 1:find a 2.6 sigma box 2:find driveshaft from l200 and fit the gearbox end to the sigma shaft

What was the motor and box from? L200 and sigma have different size output shafts

What about some kind of msd type box device?

I don't see a ld28+t there

This

You have too many scooters, giz one for cheaps

If you want a hand pulling engine, let me know and il bring tools

There was a guy on here that did it on a sigma. I think he used a RVR thermostat housing and some kind of toyota sensor Edit: this one

That would be me, havn't been there for 18months. I only have 1 complete head in my hoard and it is still on the motor, I may be getting another parts head in a couple of weeks

I got told to fill the oil pump with vaseoline or grease on assembly to help it prime

Pics no work

I'l be heading in from north. Keen for a cruise after

Did somebody contact the respective Burger fuels and let them know about the change of location?

That, and this came up cheap/means I can sell falcon

Discuss

Discuss/tell me I should lower it more

Aquired wof and wheel alignment yesterday and went for a drive today Drove over a bridge And through a long arse tunnel Credit to my other half for the phone photos. The weather has been crap the last few days so no outside pics yet