^ yea seal the seam after but where the bits will overlap get some good weld through primer it doesnt burn off when you weld and adds abit of extra protection
mean pretty hard to "chip" a toyota. Ive seen a couple with unsoldered factory micros with small board placed inbetween with a flashable chip is it like that?
Yea I swapped mine around no worries recommend you get some of the toyota gasket goo it rules. N/a pickups are sweet thats what i used and drilled and tapped the fitting for the oil drain which was available new from toyota
Hey bro you should chuck up some pics of the water setup and the dizzy as my mates doing the same thing into his starly we're still going to move the firewall but would be nice to save more space. We did exactly the same thing on the inlet manifold crack up
Het boe thats a china turbo aye whos it from? Im looking to get one as a temporary thing but theres so many and some are meant to be grenades. Had one from bazda on TS but it got pinched
cant give you exact details for the mitsi but if your noob just feed the regulated output into the regulator, It'll clip your voltage abit but will work until you get stuck in with the multimeter and figure shit out