BattleSnayke Posted June 17, 2013 Author Share Posted June 17, 2013 That's pretty much what I told him... Although, in theory if they're done right should perform as good as they look. Quote Link to comment Share on other sites More sharing options...
kyteler Posted September 1, 2013 Share Posted September 1, 2013 Yay for oil caps that look like locking racing wheel nuts. Quote Link to comment Share on other sites More sharing options...
BattleSnayke Posted September 1, 2013 Author Share Posted September 1, 2013 Best investment of my life Quote Link to comment Share on other sites More sharing options...
Beaver Posted December 9, 2013 Share Posted December 9, 2013 Caps look lush man! I talked to you at the last meet about them, what was the cost in the end? Im missing 1 for my equips so would be keen to get one made up. It was Phil (Spun by Hutty) down in CHCH yeh? Quote Link to comment Share on other sites More sharing options...
Snoozin Posted December 9, 2013 Share Posted December 9, 2013 ^ I want some for my Equips too... so if you are going to get some done then shout me a holler, get 5 done or something and I'll pay for four caps worth. Assume it's the same center size. They look lush! Looking forward to seeing this car on the streets, got a time you want to be hooning it by? Quote Link to comment Share on other sites More sharing options...
BattleSnayke Posted December 9, 2013 Author Share Posted December 9, 2013 They were $40 each, which isn't bad for something hand spun. And yep, Spun by Hutty. I've just gotta finish welding up the holes in the engine bay then it's more or less just a matter of assembling it all. I have pretty much everything sitting there except the exhaust and driveshaft Quote Link to comment Share on other sites More sharing options...
Seedy Al Posted January 5, 2014 Share Posted January 5, 2014 dude this thing looks freaken sweet! Love the exhaust manifold So, Have a question about that. How do you find the best way of matching and cutting the tubes so neatly? I for some reason always have problems with matching tubes to be nice enough, end up filling nice gaps with weld lol Quote Link to comment Share on other sites More sharing options...
BattleSnayke Posted January 5, 2014 Author Share Posted January 5, 2014 Haha as much as I would love to say I made something like that, I had them made by Steve at Frost Engineering. PVA would have a better hold than my welding Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.