ive got some wheels that need a sand blast or something of the likes, just got quotes $30+GST per wheel by one place, not too keen on that.
So if anyone knows a good place would be sweet.
Sweet i shall keep my eyes out, i'm hoping for about 130hp once i'm all finished with the engine so yeah.
I will chuck up a build thread of the car as no doubt it will become yet another out of control daily project..
considering it revs out to 7.5-8k as it is its possible.
Bisimoto loves these motors so much aftermarket parts for them.
nah nah nah, if i had a k20 it would be going in my rx7... student budget spec.
sweeeet, this thing is going to be revving out to about 9k hopefully so i may need something quite big.
No doubt i will be posting more in this thread once i start to install the carbs and go through what you guys have and try make them run right hahah.
the intake port is about 40mm at its largest.
yeah they probably aren't the best but they are super cheap so thought there may be a way of making them work. http://www.trademe.co.nz/Browse/Listing.aspx?id=706804668
sooo was looking at putting bike carbs on my car (Honda civic with a D15b) so 1500cc sohc.
Just wondering if they would be to small, they are off a cbr250rr and 30mm, Would these be too small? they should work if i drill the jets out?
those j160's are sweet. as long as you don't limiter dump everywhere and don't run a stupid clutch like a 4puk or something everything will be fine.
Looking back i should have used one on my cressida with a 1ggte. Same raitos as a w55 but 1 more gear. 4.11 final drive for both of them.
ohh fender mirrors look alot nice!
Polishing the wheels could be a good option, would make them look less fake hahah. But this thing is looking nice good work!