governorsam

have heard on toyota vans that the reverse light circut also powers the sender unit in the gearbox. mate's van blew the fuze and his speedo stopped. pull the fuze and see...

have sent you pm

keen.

http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp good place for wiring/alarm diagrams/color codes. just remember its american, so things are on the opposite side. color codes match though.

^ this. will be most of your problems most likely. ballast for the injectors/coil. (have come across it before) most cars use the same loom for manual/auto. but yea, alarms can fuck things up easily. take it out and make everything factory spec, then work from there.

want me to come over saturday morning? sounds like inhibitor switch wiring and ballast resistor/wiring.. probably a plug forgotten to be connected somewhere.

keen, still want that visor?

someone on here put a link up to the dave vizard book a few weeks ago. READ that before you do anything radical. has a lot of good advice from a clever man. found it. http://www.oldschool.co.nz/phpbb/viewtopic.php?f=1&t=31293

also keen to hear about getting flat glass cut. want to do a roof chop on morrie, but price may be a factor. can exizting toughened glass be cut?

nice and clean, look good.

put a "T" fitting into the block where the oil pressure switch is and then you can run the gauge and the light.

wrong coil is burning the points out. need a non ballast coil, or fit a ballast resistor in the power supply to the coil. sounds like the points are shorted out/ wire is on the wrong side of the insulator on the points. very common thing to do.

good turnout. nice.

get someone to pump the brakes on and off while you grab the rubber brake hose to the brakes. if you feel any movement in the hose.... replace. have come across it on motorcycles. makes things spongy cheers.

nope, this will be a budget spec fix up to get a wof and legal. then remove roof for rowdy convertible over summer. then sell/profit/use money on the morries/get my motorbike legal.

place in hazeldean rd in chch has new doortops for about $100. another $25 for the sliders. will probably go that way, seems cheap.

got the mighty 186 holden. need door tops and/or drivers door bottom. and at least 1 front hub, has grooves in it you could fall into. cheers.

get it home. inspect rust with hammer and screwdriver. remove panels, start cutting. oh god, here we go again... new pillar and chassis mount was about $140 with factory bolts and clips. and the brakes dont work.

Honda has black as power and green as earth. cars and motorbikes. fuckers. adds to the confusion that makes fire. have seen the results many times.

http://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp http://www.bulldogsecurity.com/diagrams/printpage.asp?ModelID=16328&MakeID=2

firing order?

prototype mosquito before they made them 4" wider and called it a minor.

any chance of OS stickers this time round?