fulloc

im about to move out of a 2 bed unit in ellerslie, mint quiet area near motorway, one car gge plus one park up long drive. 370pw. let me know if you want the agents ##

those last 'work' wheels are dope. pm me if you want a thermostat for like $20-30 they often open when you pour water form the jug on them but lay in wait to fuck you off on a road trip

No worries buddy, you have a good evening. zebs got that shit locked for me

wofs are easy. take a box of beers to a decent looking local shop, make friends. win

but if you flip you end up with two wheels in like 9", stetch on 175/60/14 = pimp bitches hahaha

boom. viewtopic.php?f=18&t=31376

you should have a crack flipping those wheels should look alright good luck with your mission

yeah il be taking a coil off the front any day now, trying to keep it near the 100mm limit though as im too old and poor for tickets. will put more pics up soon, goes alot better with the 5speed

no wof or something.? well if anyone wants a lift im sure my wife will love the excuse not to come. im in ellerslie gimme a pm

you wanna ride in the chaser lingling? where do you live?

im there for sure

you'll need a feeler gauge, should be about 0.4mm to 0.5mm i think.

So I finally sorted all the parts for the manual conversion, all wofd and regd -excuse the phone pic By fulloc at 2012-01-21 more to come... edit for discussion link viewtopic.php?f=18&t=31368

Just finished and wof'ed my car last night. Pretty gutted i missed this meet it looked awesome. whats the date for the next i might just make it before i move to welly 15th?

spray some carb clean over it and check for vacuum leaks

leaking inlet manifold gasket?

autostop can do it also robinson instruments in auck city do speedo cables so also may have the gear to make a throttle cable.

This stuff is good they sell it at ACL out west

<3

It may be just a stuck or gummed up ring you could try a engine flush and/or one of these upper cylinder cleaner in a can things.

choice. fyi the book said my bearing was supposed to be a 6201 but turned out to be a 6001

yea thats awesome

Series six flywheel is for pull type clutch i think so may not work. i used all series 4 parts in my s5.

Some are negative switched so check polarity. i think a 2pin toggle switch would be the go man should be resonably straight forward once you get into it with a test light.

I did this few years ago. made a mount same as shizzle says, bit of square bar welded to the original crossmember auto ecu worked fine left in neutral driveshaft was different. everything else was straight forward, pretty easy conversion