tortron

haters gon hate

http://en.wikipedia.org/wiki/Velour

rusty, are your seats velour?

what you can do with worn syncros (tho this is of no use to you im sure) is "borrow" the syncro from another gear (also helps when your 1st and reverse are straight cut) for example - when putting it in first you would move the gearstick halfway into 2nd to get the syncro lined up - then wack it into 1st

thats so bozo i almost threw up just run a straight through pipe - will be well under the dB limit

what the fuck is a rotary engine? pretty sure danger picked up an rx5 yesterday - so must be some out there. This thing is so clean looking - moreso than in the auction pictures. plans include?

sanding this sucks quite alot just putting that out there

recomended ever 15000 miles in the morrie to take sump off and scrape out the shit

that sludge is probably holding all your oil in the engine

na, you see on the goat tracks they call roads here the less dust the better

fully enclosed chains are a must (project bike will have one ) will look into this product

yuh, with this new oring chain it should last pretty much forever. am yet to find a chain lube that actually sticks to the chain and not the tyre tho

christ i still have this POS have done roughly 10,000 kms since taking ownership of this black beast (end of march) and it definitely shows as i have never cleaned it gave most of it a brush down with kero today (namely the back half as that required further work) Was fitted with a standard no oring chain, which by this point was as stretched as adjustment would allow. So i ordered a new chain and sprocket kit this morning, which arrived at about 3.30 this afternoon at my doorstep (free postage even). just need to pick up a couple of bolts for the chain adjusters and il be operational again. also i need a new rear tyre, anyone goot a deal on a 16 inch tyre?

my bet would be that you would rip the centres out in short order

morris 1800's did the same was a lush bed il tell you that

put those blinds back in or i will stab you in the eye with a conrod i love impulse buy cars

this is oldschool.co.nz - always assume pushrods giz a measurement and il pull out the parts box

get them rehardened ala reground cams

possible to turn it down past the chip and put a washer or something in pushrod adjustment?

whats the dimensions?

if i am understanding you correctly a morris minor handbrake setup could work tho re-reading it im probably way off

por loves the contaminated metal i do same as mk5corty

remember tho that i have chrome door frames to break it up a bit will get back to searching and see if i can find a pic anywhere

should i tint my windows? or will it look naff i can see it getting bloody hot inside, what with no fan or anything.