Get it done

Also i think cm trailers do a direct replacement, could be wrong though.

Disks are available last time I checked, single piece hub and disk. Heat dissipation from disk to hub is what stuffs the bearings, be sure to put a bead of sealant around the dust cap too as it will pull the moisture in from this side first turning the grease milky.

Pretty sure mk2 has the rib lines on the top.

Got a pic?

Cobalt is the go ! Good drill selection and speed should limit sharpening . A home made scratch guage and a bench grinder is all that is needed, be carefully to select the correct stone grit , a fine one for small bits and a coarser for larger bits . A cup of water can help with heating of drill edge , make sure bit doesn't blue or it won't hold a edge .

Yup still have it .

Richard at naenae panel and paint , clendon st naenae

Long yarn but... My sister , yes she was a con artist back in the day lol , note was invercargill The scam used be fake id or someone elses identity then go to car lot with a shitty car and trade with newer car , then go to next car sales etc . 4 or five yards later ya rolling in a new beamer , pay the money and change into fake id name ,or ya own then alple for a loan in ya name or somone else , change name back into car sale name and result. Made 600k in 3 weeks before she got stung , money disappeared and only got 300 hrs community service id call that a win. Didn't even get reparation wtf

Oldest ive heard of is 13yrs, a Zimbabwean fella told me how they used to make them boil to clean the plates , then drain and refill every couple of years.

Ive noticed some of the new chargers are to sensitive and to many safety features if a battery is really flat , i sometimes have to hook up another one to it at the same time to get it to start charging, Id be tempted to hunt around for one of the old ones at about 20amps. Great for electrolysis cleaning too.

Shot! Going to try it now.

Anyone tried this? Ive got preformed pipes on a transmission for the high/low shift cylinder and would like the piping to hold a tight curved shape. Any tips or tricks? Ive tried hot water then frezzing. Problem is if to much heat is applied the piping will kink.

Wiaone motors at allied garage on the foreshore ,lance is a gc and fair ,also knows and loves the older stuff

Give greg or andrew a call a mp autos in upper hutt . They can test , adjust and advise you on your set up

Do forget the bolt in the middle like my work mate , i can confirm the casting is really thin when you forget to undo it then lever it off lol

Or rare pokemon inside

Awesome write ups, so though! Nice result with the sump plug , best of all the pics look normal now must of been a rover thing a.

Love your though write ups but why are yours pictures always elongated?

You should burn sections of it so its easier to read . Had a brief look over it but can't find the smoke outlet relay

This is the actual machine , is currently setup for alloy. Ill have to work out a price and sort through all the extras i have for it , bloody typical havnt used it in nearly a year and go to sell it and now need for a job . Will be repairing some big alloy trench sheilding

Pm me i can get sharp deals on these welders, they come complete even with wire just grab a bottle and go . I have one a home its about as big as you can go on single phase

3 phase 500 amp , has alloy spool gun etc , ill post pic of machine tomorrow with a price

This Will be way to big for what u need but i have for sale a big 500 amp cebora It is a beast, selling cheap as theres not much demand for a big second hand machine

I can help if you get stuck pm me if im needed

Just a thought.. If rust work has been carried out check the earth connections theymay have been disconnected/ loose etc