Simon

After paddock cars if anyone has something that runs and drives. Willing to pay scrap value + 100ish depending on how much abuse it is likely to take. Cheers.

And the bunch of young fellas too, should have come over for a feed

Good catching up with everyone. Thanks to the Dannevirke fellas for making the trip again. That car what ever it was is awesome.

WTF are you doing with carbs. OMG stop.

I've never tried a dent that big but my first thought was slide hammer?

Nah it will be sweet. But you'll have to run 4 bolts and you'll have to snap another one off in the bolt hole directly across from the first one. Then drill it out and snap some eazy outs in it to get it all back in balance.

Super sweet! Stuff like that looks so easy when you have the right people/tools. If you had met crane dude in a pub with your dilema 3 months ago he would have been like "dw bout it I got this crane I'll just lift it in, easy" haha.

Lol. Will have another play, if I can sus the post out for that controller I'll bring it to work.

lol Yeah that one. O well as you were.

Lol yeah, It was so long ago I can't even remember what I was going to do with it. I bought it for the diff because it had a good ratio I think. I hooned down the other night after work and picked it up. Went over the kaimais for lulz and hit a wall of fog between upper and lower hutt. Was whack.

Also Jared you should send out a mass email to all your customers tomorrow. "Due to the recent raise in *one of your consumables / quality wood* our prices will rise 10%" Thx, Regards.

Lol G code reads like the German language, where you have a noun before a verb... "Make the doutside door closed" / T5 M6 rather than "Close the outside door" in english. Is the manual actually german? Can get dad to look at it as he speaks it if so.

Oh I wouldn't ask that of Seedy. Hes already dragge it from Rotorua to Wellington lol No stress tho.

No worries if not, I'll just cruise down and get it in my professional box.

Apparently Seedy has taken it all to bits. So picture this in bits. The main part doesn't come to bits. Sedans and coupes need not apply.

Lol I dented my sump before I even started the motor by pushing it out of the shed. Sump guards are very necessary. Sweet that it was an easy fix re. fuel pump!

Anyone with a ute / wag want to collect a subframe from Seedy Al this week and bring for a box of beer?

I will remember that drag race in this with 5i at the lights in Taupo till I die. No mufflers on either and a whole red lights worth of slow RPM rise till green.

I have a welbro one in mine and it draws about 7 amp, no idea what the pressure is, whatever the factory 1uz regulator is. Make sure it's not touching the bottom of the tank or it will be loud, so I found out. haha. If I took it out again I would put some rubber insulation around the clamp and lift it up a bit.

Very nice!

Nice! What's the fine for not doing all the paper work for a container house? When you get the letter just ring the swing lift and take it away the next morning. "What house?"

Just machine the face of the ones in there.

Spectacular!

Looks fantastic!

We should have a whole section of good good fabrication threads like this.