Alistair

Eh, could be keen if it was cheap and you needed to fill space. Dependant on who had access to the lockup etc. Not keen on any random kents floating around if my tool chest etc is thurr.

Pics? I shall finally be in re-attendance for Jan meat.

It was the very first Burgerfuel meet. Think there were other Auck meets before but burgs has been the regular.

Also, first meat ftlols viewtopic.php?f=20&t=16513&p=374752#p374752 Should do again in Jan for OS Aucks Kents 3rd year of meating

Fuck, that guy is parked HARD. May, just MAY be able to get to this. If not Jan will be my re-amalgamation meet.

Bring a clean car?

I'll bring 270hp and semi slicks in the wet so no excuses lol

Also, wheels look too new/clean need to sand blast them and leave to the elements or something

Nah brah, not unless I went to new link or got 5 bar map sensor for mine which makes tuning shady cause it doesn't actually increase the map zones you can tune lol. Runs 19-20psi so dependant on external factors it could regularly hit the 21psi map limit if I was to run closer to this. Is heaps enough power at the moment anyway haha, need to biff all the gear into an ep85 for some traction

Wow that was a while ago. Got this stz sorted again after a few issues. Namely a boost leak which was rectified with a new steel body OEM Evo 9 BOV. Sussed new wof/reg for it and got the road test/niggles sorted by Speedtech so I'm ready for summer track beating! Also, biffed on fender mirrors that were an option on the first 85' models complete with blanking plates where door mirrors where. Quite like them...

EP70 is os amirite? Andy?

18th and ill bring the starlet super mega turbo.

Keen for diss. Starlet should be actuals going again.

I'll likely run the ones in the new year. Skids etc.

hurry up and slide sedan.

Yeah....this is going to get moved.

Yup, go to the massive new spring section Bunnings has and grab a selection. Boost control at the touch of a spring!

Dont care. Drive to wellington you faggot. Also you should probably post this in one of the north island sextions.

Could also try Nick at North Shore Toyota parts dept and say you're from Toyspeed and see if you get any better pricing.

Got this stz all sorted. Just waiting on gasket goo to dry in the sump and flush cooling system then I should be good to doort.

The washer was still sitting seated in place and nah the head snapped off under load. Not to worry though, got a smaller magnetic pickup that could reach further and with a bit of prising managed to find it so just off to continue putting it back together. Stoked!

I don't think it would run 20 odd thousand kms on 16psi with a head bolt missing. Stumped me though. I need a thin flexible prod as the head on my magnet is too large. Only place I havent been able to get at is a small section of the oil drain from the block to the sump which I should have really done when I had the head off and expected it to be in the sump. Doh.

Balls. I cant find it in either oil drain, nor the sump. Unsure hwhat to do. Not keen on running with a bolt head somewhere in the system lol. To tear down or not....

God this car makes me want to build a Patrick watts pug 406 replica.

Haha the 10nm was a reference, I need 13nm for the cam caps as Kris suggested. Not sure how important this is. Ive got them tightened evenly just below the scale of where my wrench goes to (19nm) where I estimated 13 would be but I should really do them properly lol.