di0n Posted April 8, 2014 Share Posted April 8, 2014 So I'm looking at possibly building a full new chassis for my Chevy Thriftmaster. There's a lot of stuff I need to sort out and plan but my first question is, does anyone know where I can get 4x2 box section mandrel bent for the rear chassis section over the diff? The bottom right pic in this link is what I'm after. http://www.artmorrison.com/2006cat/30.pdf Quote Link to comment Share on other sites More sharing options...
danger Posted April 8, 2014 Share Posted April 8, 2014 Fabricate it from sheet? 2 Quote Link to comment Share on other sites More sharing options...
Ned Posted April 8, 2014 Share Posted April 8, 2014 Autobend can do box round and oval Quote Link to comment Share on other sites More sharing options...
di0n Posted April 8, 2014 Author Share Posted April 8, 2014 Thanks Ned, I'll do some drawings and give them a call. Quote Link to comment Share on other sites More sharing options...
Rookie Posted April 8, 2014 Share Posted April 8, 2014 Most people who make custom chassis fab them from sheet. Quote Link to comment Share on other sites More sharing options...
My name is Russell Posted April 8, 2014 Share Posted April 8, 2014 Get water jet cut and weld up? 1 Quote Link to comment Share on other sites More sharing options...
Rookie Posted April 8, 2014 Share Posted April 8, 2014 That way you can pinch the rails easily too. Quote Link to comment Share on other sites More sharing options...
Stu Posted April 9, 2014 Share Posted April 9, 2014 Auram Engineering - rolling guru Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.