J-W-G Posted April 3, 2016 Share Posted April 3, 2016 So the printed circuit board on the rear of my cortina dash clusters is fraying and the plastic insulation has lost its stick with the glue leaving the circuit exposed in places. Whats the best way to fix this? Conductive glue around the circuit then normal glue to press it all down? Quote Link to comment Share on other sites More sharing options...
thegreatestben Posted April 3, 2016 Share Posted April 3, 2016 Strip it off and iron it? Quote Link to comment Share on other sites More sharing options...
- i5oogt - Posted April 3, 2016 Share Posted April 3, 2016 pre-facelift dash? think i might have a good spare one in the shed Quote Link to comment Share on other sites More sharing options...
flyingbrick Posted April 3, 2016 Share Posted April 3, 2016 Much if that flexible PCB could be replaced by normal wire and crimp on eye terminals 1 Quote Link to comment Share on other sites More sharing options...
dwlee Posted April 4, 2016 Share Posted April 4, 2016 Have a look at how these guys do it 3 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.