cute wee gem Posted April 24, 2011 Share Posted April 24, 2011 Hey guys. I just made up a new clutch line and tried to bleed the clutch. The fluid is staying in the resivour and not getting into the lines (valve at the slave is open) The lines are new and completely full of air, is there a trick to getting the fluid started? Quote Link to comment Share on other sites More sharing options...
Brock-Lee Posted April 24, 2011 Share Posted April 24, 2011 You have pneumatic bleeder? Quote Link to comment Share on other sites More sharing options...
jakesae101 Posted April 24, 2011 Share Posted April 24, 2011 you could try pressurising the master cyl slightly Quote Link to comment Share on other sites More sharing options...
eke_zetec_RWD Posted April 24, 2011 Share Posted April 24, 2011 blead the master to get it going, or pressure in resivour a tad Quote Link to comment Share on other sites More sharing options...
cute wee gem Posted April 24, 2011 Author Share Posted April 24, 2011 All sorted. Pulled hardline off at the master cylinder and there was nothing coming out So half way through pulling the master cylinder out (figured it was shagged) it squirted at me, put it back in, bled and now it works sweet Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.