slickyddyer Posted March 27, 2012 Author Share Posted March 27, 2012 Had a victory getting the thing out - yes an old spigot bearing! Was extremely difficult under the car But now the hole looks like this! Quote Link to comment Share on other sites More sharing options...
slickyddyer Posted March 27, 2012 Author Share Posted March 27, 2012 Might put some lock tight around the new bearing...Any objections to that? Quote Link to comment Share on other sites More sharing options...
KKtrips Posted March 27, 2012 Share Posted March 27, 2012 Would be your best bet.. Quote Link to comment Share on other sites More sharing options...
Valiant Posted March 27, 2012 Share Posted March 27, 2012 Do that. The green bearing stuff. Quote Link to comment Share on other sites More sharing options...
sholdowa Posted March 28, 2012 Share Posted March 28, 2012 Next time, http://www.yotatech.com/f128/pilot-bear ... eo-186422/ Quote Link to comment Share on other sites More sharing options...
Esky_addict Posted March 28, 2012 Share Posted March 28, 2012 sometimes you can run a weld around the inside of a pesky outer race. when the weld cools it shrinks the race. Quote Link to comment Share on other sites More sharing options...
slickyddyer Posted March 30, 2012 Author Share Posted March 30, 2012 Got new bearing in with some lock tight and new clutch installed. Gearbox tomorrow! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.