Josh Posted July 5, 2007 Share Posted July 5, 2007 Ok so the injectors Ive got are 2.2 OHMS, what I want to know is should a injector resistor be inserted in the line so I dont kill the computer? (Link LEM V3) Cheers Quote Link to comment Share on other sites More sharing options...
Burntrubber Posted July 5, 2007 Share Posted July 5, 2007 Depends if the injector drivers in the Link can handle it. Have a look at the specs if it says it supports PWM (pulse width modulation) it'll be able to run low impedance injectors. Quote Link to comment Share on other sites More sharing options...
mikuni Posted July 6, 2007 Share Posted July 6, 2007 I think mine were low impedance and my LEM G3 manages them fine. I will double check tonight for you. Quote Link to comment Share on other sites More sharing options...
eke_zetec_RWD Posted July 6, 2007 Share Posted July 6, 2007 u will need resisters, link supply them - the ones link supply have heat sinks cos they will get quite hot. Quote Link to comment Share on other sites More sharing options...
kpr Posted July 7, 2007 Share Posted July 7, 2007 1 - 2 ohm on each drive, at least 25w. i use 1ohm 50w per drive on my old link plus. 50w ones will heat up less than 25w ones. should be able to get then from jaycar and the likes cheaper, than from link. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.