Banter Posted June 17, 2014 Share Posted June 17, 2014 Hi guys, I'm looking for a bit of advice on what to do about O2 sensor relocation. I've bought myself a set of old headers from a 2tg for my 2tgeu. I need to modify them to accept the 2tgeu O2 sensor, which is tapped into the cast manifold. Is it important how far along the extractor the sensor is located? Is it important how many cylinders the sensor receives exhaust from? Thanks, Andrew Quote Link to comment Share on other sites More sharing options...
Ned Posted June 17, 2014 Share Posted June 17, 2014 should have it where they all meet, and not too far down. The closer to the motor the better generally. Also make sure you dont mount it too low. Between 10 and 2 (like the clock) is generally the prime location 1 Quote Link to comment Share on other sites More sharing options...
Banter Posted June 17, 2014 Author Share Posted June 17, 2014 Thanks for the quick reply, I'm not entirely sure how I'll do that without having the sensor quite far down the extractor, as the extractor is a 4 - 2 - 1 type thing. Thanks for the help! Quote Link to comment Share on other sites More sharing options...
Spencer Posted June 17, 2014 Share Posted June 17, 2014 Far down is fine man. 1 Quote Link to comment Share on other sites More sharing options...
downtrail Posted June 17, 2014 Share Posted June 17, 2014 Yeah far down is fine as long as there are no leaks prior to the sensor as it'll draw extra air in causing false readings. as above don't mount it past 90 deg as condensation will settle in it and quickly ruin it. straight up and down is fine. 1 Quote Link to comment Share on other sites More sharing options...
Banter Posted June 17, 2014 Author Share Posted June 17, 2014 Thanks for the advice guys, greatly appreciated. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.