ThePog Posted January 31, 2011 Share Posted January 31, 2011 please please beers in it for you.... PM me the loving Quote Link to comment Share on other sites More sharing options...
RUNAMUCK Posted January 31, 2011 Share Posted January 31, 2011 I think butler auto mart rents them out. The secret to doing it good is to run the drill really slow that you can move it up and down fast enough to get the correct pattern in the bores. Quote Link to comment Share on other sites More sharing options...
ThePog Posted January 31, 2011 Author Share Posted January 31, 2011 its all good, I found one. Last time I did it I found the greatest difficulty was getting rid of the half mm step in the bores, quite frankly getting a nice pattern was of secondary importance... Quote Link to comment Share on other sites More sharing options...
RUNAMUCK Posted February 1, 2011 Share Posted February 1, 2011 The lip at the top of the bore? To waste that you need to use a different tool called a ridge reamer. Quote Link to comment Share on other sites More sharing options...
heavenrock Posted February 25, 2011 Share Posted February 25, 2011 The aim of the cylinder bore honing is to make the sidewalls roll straight and smooth. It should not be conical and spherical must as you can get it if you will be able to obtain a minimum distortion. Quote Link to comment Share on other sites More sharing options...
ThePog Posted February 25, 2011 Author Share Posted February 25, 2011 its all good, I found one.Last time I did it I found the greatest difficulty was getting rid of the half mm step in the bores, quite frankly getting a nice pattern was of secondary importance... http://en.wikipedia.org/wiki/Irony Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.