Hi,
I am trying to track down a panel beater in Hastings who apparently has the moulds for a FD Victor body kit.
Or alternately how would I go about a mod without the moulds for wheel arches fairing etc
thanks
Jim
Does anyone know how to get compliance for glass ?
IE some of my Victors windows are not stamped
Therefore in order to get compliance they have to be signed off by a glass specialist ..... ??
and that is just the beginning
Sorry I have not replied...can't work this site out... how to load pics etc...only just found this thread.
BUT
Drove the 3.3 today ffor the fist time...very tight !
rebuilt the brakes.... amazingly Apex in Hamilton had everything I needed or built it.
Putting it over the pit Monday at Nostalgia Motors for compliance and new rego
This one came with extractors and twin carbs
If you still want pics sing out
I am doing up a 1970 3.3 Victor.
It runs great however it has not been registered for 20 years !!
Can any one advise what i will have to do to get it fit for new registration ?
thanks
Jim
Just managed to find (and buy) a very rare 1970 Vauxhall Victor 3.3 with twin carbs and 4 speed floor shift. These cars were very quick.
Has only 45,000 miles on it and surface rust only.
I intend to rebuild from the ground up.