oldrx

Is it possible to buy new outers for longchamp xr4s? Looking at some that might be ok but offsets are + . Possible to change to neg offset with different outers? Dont know much about wheels so im probably way off course here. Cheers Nick

Hard top shell $500 on trademe. http://www.trademe.co.nz/Trade-Me-Motor ... 896708.htm

POR15 sell a fuel tank repair kit, used on my mazda works well.

Thats a set price per wheel regardless, thats what i understand it to be anyway. Cheers for the link - the max you can legally widen steel wheels according to that lvvt link is 76mm on a wheel over 10inches in diameter. Does anyone know what width tyre range I could get on a 7.5 inch rims?

None of it is a direct bolt on. The Rx7 crossmember is no use at all. Brakes - maybe with backing plates and other mods. Fuel pump - probably not. If you're going NA carby motor then obviously it will be way too high pressure. If EFI NA maybe. If EFI Turbo - maybe if its standard which is unlikely so again probably not.

Sorry, tried searching but didnt find that for some reason.... Price update as at October 05 for anyone wondering; - Arrow Wheels in Auckland send them to Elite Wheels in Chch to get done. About $100 - 120 per wheel including freight. - Elite Wheels Chch charge $90 for 1, $120 for 2, and $200 for 4. All plus GST. So - $101.25, $135, $225.

I've heard of people widening factory steel wheels... Has anyone done this? Is it street legal? How much did it cost? Looking to get my factory 14s widened to get a bigger tyre on there.

Just had a look at the workshop manual and the figures i stole above are correct. Also from the manual; "Apply Loctite..." - Good idea "Assuming that most home mechanics will not have a torque wrench hich will read this high, you can achieve thi figure by using a length of pipe over your torque wrench. 100 pounds of torque applied 3 1/2 feet from the nut will give a torque equal to 350 pounds" - Pretty good idea too

Yeah they are real tight mother fkers! Heaps of fun taking them off!

40.0 to 50.0 m-kg, 289 to 362 ft-lb - Thats off another forum. Ill check my workshop manual when when i get home if i remember