craw Posted October 5, 2014 Share Posted October 5, 2014 Just trying to start my 1600 crossflow and ive got no spark theres power at the coil but not coming out the center where the lead goes one Quote Link to comment Share on other sites More sharing options...
bogangeof Posted October 5, 2014 Share Posted October 5, 2014 Points? If they don't break you don't get spark to king lead Quote Link to comment Share on other sites More sharing options...
craw Posted October 5, 2014 Author Share Posted October 5, 2014 o spak at the points should there be poWer at the neg side of the coil? Quote Link to comment Share on other sites More sharing options...
craw Posted October 5, 2014 Author Share Posted October 5, 2014 No spark Quote Link to comment Share on other sites More sharing options...
craw Posted October 6, 2014 Author Share Posted October 6, 2014 Got spark now new points and condenser done the trick thanks Quote Link to comment Share on other sites More sharing options...
Seedy Al Posted October 6, 2014 Share Posted October 6, 2014 Make sure you put a little bit of grease on the lobe of the dissy where the ppints run on to open and close. Stops them wearing out quickly abd loosing there gap. Quote Link to comment Share on other sites More sharing options...
craw Posted October 6, 2014 Author Share Posted October 6, 2014 Will do thank u Quote Link to comment Share on other sites More sharing options...
Frosty Posted October 7, 2014 Share Posted October 7, 2014 Check the earth wire inside the the dissy, they can break or forgotten during a service. Wire should go from the body of the dissy or the lower fixed plate to the moving plate (the one the points screw to and is moved buy the vacume advance). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.