bobdylan

My car today at 2500rpm http://www.flickr.com/photos/117293653@N07/12474935533/

I can do somethings but electrics confuse me

Does anyone know if in an ae82 the lights have a relay stock?

So the dash is almost ready and we are moving onto the switch panel for low beam, high beam, indicators, hazard, fan and fuel pump. What amp ratings do i need as minimum in the Toyota to run the lights/indicators and hazards? I have found some 3amp ones which look ok but i know nothing about electrics.

If the aftermarket guages Will occupy the same space and are not forward of the stearing wheel that's fine isn't it?

Yeah but i need to find out a clear yes or no. cause if its a no i need to find a working dash unit. But i read the online wof requirements but could not find anything. Maybe its covered in the asseser one.

Generation 1 apex RSM uses a sensor so is legal. I had just finished removing the dash cluster and about to start to replace it with the alloy panel when my cousin (who is a wof inspector) said that unless the car retains its stock cluster its not going to get a cert or a wof as it must remain stock. Read the wof requirements but could not find anything. please can someone shed some light on this for me? I think i have just wasted money on my race-looking dash instrument cluster.

I have a strange question. Do you need to keep the stock gauge cluster to get a wof? Was told if i remove it and replace with autometer gauges i need a moyorsport licence? Any one can shed some light on this?

I have the instruction manual for the gen 1 & 2 ones. pm me your email and i will send you the pdf

Thank you.

I had the right parts and have lost them. Have to buy new ones, but need to go home on wednesday. Thanks guys. You have been great.

Can they be made to fit.... OR Does anyone have stock silvertop ones in Auckland today or tomorrow I can pick up?

F$^##!$ ! Cheers for that guys

Quickie answer needed please, i have "Lost" my 70mm Trumpets for my silvertop and need a urgent replacement, have a set of blacktop stock ones, will they fit? Can they be made to fit?

Sorry i know i have asked this before but need some more advice. Do i need the heater/fan unit for a wof/cert ? Do i need a speedo or can i use like an apex rsm instead?