Not-a-number

Bugatti T57/59 Engine Project

Recommended Posts

I have a challenge for you guys.

Im look for OEM parts to design around. Starting with Shell bearings and Con Rods.
 
Bearings:
Big End. 45mm Diameter. 35mm wide
Mains. 60mm diameter 28mm wide
 
Con Rod:
180mm long
45mm bearing (49mm? bearing dependent)
35mm wide
 
Ive found Subi main bearings in the EG33 are 60mm diameter but they dont look wide enough. Old 911 looks close too.
Same problem with the big end. Lots of 45mm diameter but not wide enough.
 
The conrod length is super long. Ford Model T or Flathead are 7in which would be fine. But journal diameter is too big.
 
Hoping you guys can help figure out a combo.
  • Like 3

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.