sentra

ok

keen to lend a hand

re neds comment, he next time i get the victa bike going its to swim & camp crawl great barrier island

 

https://www.google.co.nz/maps/dir/-36.2596586,175.4344317/Port+Fitzroy,+Great+Barrier+Island+0991/@-36.2323749,175.3281384,12z/data=!4m9!4m8!1m0!1m5!1m1!1s0x6d736caf45c44865:0x14ebfaf6019c7f8c!2m2!1d175.3626406!2d-36.1639848!3e1

 

http://www.sealink.co.nz/great-barrier/fares

 

timeframe no later than easter weekend

 

if any ones genuinely keen get in touch

motorsport electronics on marua rd is about the only walk in place in auckland you can grab one in a hurry

good work sheepy.

for my bi-curiousity, how far off the mark was the tightness?

^weld the diff for capital gains

- no unregistered aircraft in the parking lot

there was a guy called hotdog on here and his forklift motor powered starlet was faaaaaaaaast

 

do whatever he did.

not a lot of #hype this month!

keen for burgers and spinning shit yarns

 

the five hundred and twenty six words in the rules post dulls a mans enthusiasm!!!!!

 

if we had an extra hundred words we would have 626 rules,

 

 

Block the nozzle and pull trigger to blow all the shit back out the pickup

whenever ive used those little cabinet blasters you have to do this every like 20 seconds, once we tried messing with diffirent garnet and guns with no success and just put up with it. must be missing the magic.

in for another season of mechanical failures, or will the zero preparation strategy pay off this time?

 

lets go racing.

 

 

a topical interesting read http://www.slobc.org/safety/documents/road-survival-guide.pdf

yeah had a bit of a meltdown woth the old phone-posting-while-driving-combo

oh yeah, it is the same plug with its foreskin pulled back and forward, the others are all ok

edit double post

its been degloved?

looks sore

any ideas or just a manufacturing defect? ethanol turbo motor

yusssss

it doesnt got a roof!

keen

And heres my grinder , havnt sat the grinding head back on it yet. Had to remove it get the weight down, think it comes in just over 4t

And yes I know its a cylindrical grinder but its pretty easy to offset grind with these machines.

http://s249.photobucket.com/user/ja1lb8/media/20160625_101418.jpg.html

awesome stuff, out of curiosity as i have never seen it - offset grinding on these machines, do you do disconnect the leadscrew and connect a link bar from another rod journal, or do you have to make a plate with offset centers for each end of the crank to run it between centers? or some other magic? i have been thinking about doing it in a really shitty manner with offset center plate and a toolpost grinder..

man i gave up trying to measure it and just cross sectioned a block with a saw to check properly, i worried that the roughness of the casting was accounting for too much of the reading when allready on the "limit"

there are some interesting posts i think on jolopy journal talking about some dude building (successful) v8 drag motors and after years of running the same combo he measured the walls and they were paper thin like 2mm and down to 1 at the bottom

15point7.com Spartan 2

the lean burn edition