Mr Currie Posted May 12, 2012 Share Posted May 12, 2012 Hey all been chipping away at this for a while and thought I would start a build thread. I picked up a S1 RX7 roller last year and have since stripped it back to a shell and am now rebuilding it. Here it is: Start of build. Hill billy car hoist: Stripped her right back to a shell. Getting that sound proofing out was a bitch! Before After Had her sandblasted and primed, wouldnt go down that path again to much sand shit to clean up. Acid dip for my next project. Dealing to the rust! Then got her rolling and seam weld her under body. Just waiting on some seam sealer so I can seal up the underboy and then put some of that thick paint crap on. After that I can put her sexy new lsd diff in! Quote Link to comment Share on other sites More sharing options...
Mr Currie Posted May 20, 2012 Author Share Posted May 20, 2012 Discussion... viewtopic.php?f=18&t=33674 A small distraction from the 7 arrived this week.... Just trying to work out how to fabricate a 4 link setup on my diff and set up the watts linkage. If anyone has experience in this perhaps some pictures I would really appreciate it. Quote Link to comment Share on other sites More sharing options...
Mr Currie Posted May 27, 2012 Author Share Posted May 27, 2012 Just about finished fabricating a S4 RX7 subframe onto her Quote Link to comment Share on other sites More sharing options...
Mr Currie Posted September 30, 2012 Author Share Posted September 30, 2012 Rear end finally in, just needs a few spacers to tighten things up Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.