Jump to content

rodney007

New Members
  • Posts

    6
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

rodney007's Achievements

Newbie

Newbie (1/5)

1

Reputation

  1. Update: Lancer FWD powersteer unit with idler Large front mount intercooler and 2.5" piping Oil catch tank setup battery relocated to the boot Racing clutch kit
  2. whats the condition like?, would you do 650 with no shocks?
  3. Thanks, I actually have a standard heat shield, might dig it up and chuck it on. Nice point on the fuel reg lines too. It runs really good, smooth engine with nice solid pull. The injectors came from the same car as the ECU. doesn't seem to run rich though I haven't had it officially checked at this stage. As for the skid, not a hell of alot I can do with the open-diff. I had a locker in there a few years back but she got thrashed and almost got me into trouble a few times.
  4. Discussion: //oldschool.co.nz/phpbb/viewtopic.php?f=18&t=32108 Hey dudes.... Been a while since I have been on the forum. Went to a cruise with you guys ages ago when the car was near stock. There has since been some work done and I thought I would upload some pics for yah. I have owned the car for coming up 5 years now. The car was an auto-matic SOHC in pretty average condition, I converted it to manual some years ago and did some basic mods like inter cooler, exhaust etc. About 4 months ago she poped the head gasket which was a good enough excuse for me to take the engine to the next level. Here is a few specs on her: Car: 1982 Mitsubishi Starion GSR III Engine: Starion block (rebuilt) Lancer Evo 1 head (rebuilt) ARP head studs 3 Layer steel competition head gasket Racefab intake manifold Galant VR4 Evo 0 throttle body Custom top mount exhaust manifold T04e Turbocharger 38mm external gate Lancer Evo 7 560cc injectors Galant VR4 Cas Fuel pump re-wire Rising rate adj fuel pressure regulator Lancer Evo 1 RS loom Lancer Evo 1 chipped ECU Galant VR4 Inter cooler 2.5" straight through exhaust no cat 3" intake Greddy type rs blow off valve Simota pod filter Oil cooler Driveline: Starion 5 speed gearbox L200 flywheel/pressure plate Heavy duty clutch plate Suspension: King springs bushes replaced Body: Aftermarket side vents 3 piece Starion rear wing Some pics: Look forward to catching up with some of you guys in the future on some cruises... peace
×
×
  • Create New...