kos420nz

Anyone know if jzs145 crown are same suspension bolt up as a jzs147 aristo ?

You can chop/shorten/modify the rods on the height sensors in each corner. mate did it in his soarer. But its the cheap way of doing it.

Try looking on the rear toe arms for the rear height sensor rods

This gives you a fair idea about the height you can drive at though

Awesome thanks for that , had a wee look today . Looks like there is one on each side in front but only one in rear ? Did you cut your ones , if so how much did you take off it ?

Anyone know of where to get one of these so called controllers , have trooled google but cant comr up with anything ??

They are in the rear as well, one sensor for each corner.

The isolation switch should be located in one of the side compartments in the boot. If you have an owners manual it will show in there.

I would highly recommmend not touching the rods and sourcing a height controller as if you don't know what your looking at you may botch modifying them.

Ok thanks for that , where would i source a controller from ? might give adjusting those rods a go . Other option is change it to spring shock if anyone knows of a set floating about ?

Thank you , are these rods in each corner , can only see the front two , anyone based in chch come look ??

What does this isolation switch look like ??

easiest way is to adjust/shorten the rods on the height sensors in each corner.

Just make sure that you use the isolate button for the air ride system, it should be located in the boot I think.

Can get height controllers for these as spencer mentioned which is better in my opinion as its easy to revert to stock

Thank you , are these rods in each corner , can only see the front two , anyone based in chch come look ??

Can you move / adjust the level sensors at each corner?

No dont think so , havnt really looked . Txt me on 0211580577 if anyone can shed any light

Basically want to get it to a height where i can drive it comfortably , atm its either fkn jacked ir super slammed and bouncy as hell .

Anyone on here know much about toyota crown jzs145 airbag suspension and how it works and if you can make it height adjustable

Are the correct plugs in it?

 

Does it have points? Replaced the points AND condensor?

Done all of the above 

Hi Guys, 

I have a Corona tt132 

have recently , put new spark plugs in , set timing , leads , coil , cleaned carb and set fuel mix to 2.5 - 3 turns out, set idle mix , all that jazz . now has devoleped a miss up high around 5 grand and above.

Any ideas what it could be, am stumped ... 

keep us posted on this august meet up in hamner .