dr.wylde

Might be able to come out (I work most weekends) I live 5 mins south of Waimate   If I turn up I'll keep an eye out for yas 

set it up as a tow truck

that'd be rad!!!

soooo your tonner.... I reckon it needs some big truck smokestacks.

you sad sad man! British car aids Have hit you hard.

As a doctor I prescribe you 6 litres of American LS engine to treat this problem. followed up by a T56 gearbag.

very nice! 

I disagree with the above. needs twin cam head, ITBs, spaghetti headers and the lumpiest cams you can find for max dort

yes... do this

Can you paint this canary yellow on silver steels, and make it go zutututu, kthxbai.

Haha BT1 clone that would be a first!

https://en.wikipedia.org/wiki/List_of_GM_bellhousing_patterns

Wiki says the bellhlusong pattern is much the same as other GM stuff, just requires a starter relocation.

Weights apparently roughly 215kg with all ancillary equipment installed.

so a trans out of a VN V6 will bolt up with little modification if any    MAAAYTE

does it run the standard chev bolt pattern at the back of the block?

The Cheapest option is Usually One of the more expensive options up front!

buy quality 

buy it once

done

Yeah! as these boys have said dont get the chingy wing dizzies. unless you like 50 degrees of advance timing and faulty running.

have you considered a pertronix electronic ignition to convert you points dizzy into an electric?

My Q-jet does that anyway. If I don't drive it for a week I have to crank it for 15-20 seconds to fire it up. So I'm used to it. LOL

 

same here. wind over for 20 secs waiting for the gas. then boom!    

Well! its been Fucking ages since I last updated this.

still no WOF

no Reg

no nothin!... such a shame... well not quite

on the 2nd of May I got married. so I trailered this up to Lake Ohau for our wedding. 

where both this and my Brother inlaws HZ suffered from overheating problems so they were more just there for show than anything else

for the rest of May I tried to figure out why it kept overheating turns out it was a BHG 

more on that later

cheers guys

that shot of your trans covered in grime made me giggle.      When i yanked my engine and trans out  the trimatic auto was covered in crud almost as bad as yours.

but yours takes the cake!

Leaving it to the insurance companies will only turn NZ into the mess the UK has.

Fuck that

quality rebuilds (google it)  can re curve dizzys

bloody good service too I got my Bosch HEI checked over by them and my vac advance re furbed as well cost a little over a hundy

Roller cams are awesome

That is all

Please strap a blower on this

I use a trx420 at work ripper wee quads. Oodles of torques. Also do sweet drifties in the mud

Nice project btw

So wishing I had thrown a chev in my stato. So cheap to rebuild !

Pretty sure you can buy ex-uk they still manufacture the body shells so a repro loom would be possible

Mini spares.co.uk

Much awesomeness

HOT DANG! yes I do. I wish I could but yeah money is tight just paid for a wedding and starting a new job in June

LSD!!! Nice I'm rolling a single pegged but am looking for a 3:36 ratio for sum up and go

it varies I paid $120 for a sump and pickup 4 years ago and the pickup was shagged.  Just gotta keep an eye out I suppose and jump on a deal where you dont feel like you are being ripped.

Spot on kahmahl!