felixx Posted August 30, 2021 Share Posted August 30, 2021 So few years ago I acquired a little chain saw. It was seized I was told. Perhaps a McCulloch mini mac 3 or 6 Very similar to this one. It sat in my shed after I poured ATF/acetone mix in the spark plug hole and left it after it was still siezed 1 Quote Link to comment Share on other sites More sharing options...
felixx Posted August 30, 2021 Author Share Posted August 30, 2021 There it stayed until yesterday when it fell off the shelf. And its handle broke. I stripped it down and found its clutch had smashed and it wasnt siezed. I put fresh fuel and a dash of ether in the carb and it ran for 10 sec 1 Quote Link to comment Share on other sites More sharing options...
felixx Posted August 30, 2021 Author Share Posted August 30, 2021 Anyway then the pull start jammed and the only way to access it was by removing the motor. So I have stripped it down. I epoxied the handle together too Fingers crossed it holds However I cannot figure out how to connect the throttle linkage while the engine is in place. And cannot get the engine in place with the linkage connected 2 Quote Link to comment Share on other sites More sharing options...
felixx Posted August 30, 2021 Author Share Posted August 30, 2021 So my challenges are 1) reassemble... youtube may help 2) source a clutch 3) prune prune prune Quote Link to comment Share on other sites More sharing options...
Popular Post felixx Posted September 1, 2021 Author Popular Post Share Posted September 1, 2021 This runs. Is smokey as farq Wont rev hard but as half the clutch is missing thats not a priority just yet. 11 Quote Link to comment Share on other sites More sharing options...
felixx Posted September 1, 2021 Author Share Posted September 1, 2021 Hi team.. Looking for clutch/flywheel and manual oil pump spring for this thing. does anyone know of someone thay stocks vintage parts Quote Link to comment Share on other sites More sharing options...
tortron Posted September 1, 2021 Share Posted September 1, 2021 lots of parts on ebay. postage is lots tho 2 Quote Link to comment Share on other sites More sharing options...
yetchh Posted September 2, 2021 Share Posted September 2, 2021 Yeah, there's heaps of parts in the states for us made stuff. But who knows how long it'll take to be delivered. Last thing I bought at the beginning of the year to 7 weeks. 1 Quote Link to comment Share on other sites More sharing options...
tortron Posted September 2, 2021 Share Posted September 2, 2021 2-3 weeks for the stuff I have gotten recently. But might be better looking for a complete saw here 1 Quote Link to comment Share on other sites More sharing options...
Geophy Posted September 7, 2021 Share Posted September 7, 2021 On 02/09/2021 at 20:13, tortron said: 2-3 weeks for the stuff I have gotten recently. But might be better looking for a complete saw here Is this the thinking that has lead you to own 10 Dr200s at once? 1 Quote Link to comment Share on other sites More sharing options...
tortron Posted September 7, 2021 Share Posted September 7, 2021 basically that, because i can just buy whatever cheap bike and have enough parts to get it going and sell for max profit $30 a side cover, $100 a wheel or $400 for a whole bike Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.