Pee Dubs Posted May 15, 2021 Share Posted May 15, 2021 Picked this thing up a couple of months ago. Is pretty stuffed + a non-runner, so I’ve been very slowly trying to figure out what’s wrong without breaking the bank. 1 Quote Link to comment Share on other sites More sharing options...
Pee Dubs Posted May 15, 2021 Author Share Posted May 15, 2021 Seat is clearly fubar. Spare Chinese junk seat sitting on doesn't look too bad for a cheap replacement. Quote Link to comment Share on other sites More sharing options...
Pee Dubs Posted May 15, 2021 Author Share Posted May 15, 2021 First step was to clean out most of the grease and grot so I could remove and properly inspect it. Then engine out and cleaned up the top end that had bits floating around after timing advancer flew apart. 2 Quote Link to comment Share on other sites More sharing options...
Pee Dubs Posted May 15, 2021 Author Share Posted May 15, 2021 I don't want to spend too much $$$ on a little old engine, so mainly just cleaning it up + replacing the obvious. Locating pin on the camshaft had been smashed out, hoping a replacement bit turned up and jammed in will hold ok. 2 Quote Link to comment Share on other sites More sharing options...
Popular Post Pee Dubs Posted November 9, 2022 Author Popular Post Share Posted November 9, 2022 So yeah life sometimes gets in the way and the motivation slips a bit... Thanks to some GC's for getting me enthused about this again! I'm pleased to report some progress in the right direction finally - just a dummy reassembly after a few licks of paint and new head bearing, but having it look like a bike once more after months as individual parts has me keen to get it all back together and running again. Cheers 10 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.