Jump to content

the malossi meat stroker


rumrum

Recommended Posts

  • Replies 79
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

cheers mayte, yeah alot of piaggio vespa gilera parts interchange, like the centre stand is pretty much for every Italian 50cc...

so hoping an early model piaggio zip will come close, might a mm too small but meh can stretch 

Link to comment
Share on other sites

6 hours ago, peteretep said:

Dont forget idle jets, main jets, needles. And rollers too

correct jets come with bigger carby, rollers come with multivar kit ill also be putting in a new belt, tourqe driver, clutch, clutch bell housing, reeds and intake manifold that can mainline a boost bottle direct 

  • Like 1
  • Haha 1
Link to comment
Share on other sites

14 hours ago, rumrum said:

then crankshaft and port match/polish

I'm always blown away by how far out tbe ports etc can be from "matching". Simple blueprinting can make these little motors so much snappier and responsive.

Link to comment
Share on other sites

29 minutes ago, Kimjon said:

I'm always blown away by how far out tbe ports etc can be from "matching". Simple blueprinting can make these little motors so much snappier and responsive.

yeah man, especially the Chinese clone copies, half of the exhaust ports are normally blocked, a die grinder and a dremel a d you can make them fire breathers 

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...