Get it done Posted August 7, 2018 Share Posted August 7, 2018 Anyone tried this? Ive got preformed pipes on a transmission for the high/low shift cylinder and would like the piping to hold a tight curved shape. Any tips or tricks? Ive tried hot water then frezzing. Problem is if to much heat is applied the piping will kink. Quote Link to comment Share on other sites More sharing options...
Mof Posted August 7, 2018 Share Posted August 7, 2018 I've done it with a heat gun. It doesn't take much, heat the whole curve and bend it slowly. Stretch the outside and sides rather than try and compress the inside of the curve 1 Quote Link to comment Share on other sites More sharing options...
Get it done Posted August 7, 2018 Author Share Posted August 7, 2018 Shot! Going to try it now. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.