Jump to content

Bugatti T57/59 engine


danger

Recommended Posts

  • Replies 231
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

5 hours ago, BlownCorona said:

shit that's going to be a large motor!

i had in my head that those parts were the profile of the crankcase and that part housed the crank gear like a standard engine would have a timing gear case on the front of the block

Yeah its pretty big.

Banana for scale. 

Cepva6Jl.jpg

Also mm for scale. Its about 1020mm long.

HOb2DYyl.jpg

About 700mm tall

zMgyyOal.jpg

  • Like 6
  • Thanks 2
Link to comment
Share on other sites

  • 2 weeks later...
1 hour ago, 00quattro00 said:

Whats wrong with using 350 as opposed to 250?

Nothing, just that it will be harder to do by hand.

 

6 minutes ago, anglia4 said:

Its higher tensile material. Nominally 350MPa yield strength as opposed to 250MPa.

To form it over the mandrel you need to be able to "yield" it, so the higher tensile would need more force to bend to yield.

@Not-a-number will you be heating it to form?

Hopefully not but probably. Ive heard if it was G350 that would  probably crack and distort it. Since it would be locally annealing.

Link to comment
Share on other sites

  • 2 weeks later...
On 14/10/2020 at 22:36, IvyMike said:

What resin do you use for your castings and at what ratios? The quality looks great.

Techniset 6435 with catalyst 712. Its a 3 Part system.

Part 1 + 2 = 1.8% of sand mass

P3 = 3% of Part 1.

Sand is #90 so quite fine.

3 part system works way better than the 2 part I used in NZ. Mixes really evenly with hardly any effort.

 

 

  • Like 2
  • Thanks 1
Link to comment
Share on other sites

  • 4 weeks later...
  • 2 weeks later...
  • 4 weeks later...
On 16/10/2020 at 21:55, Not-a-number said:

Techniset 6435 with catalyst 712. Its a 3 Part system.

Part 1 + 2 = 1.8% of sand mass

P3 = 3% of Part 1.

Sand is #90 so quite fine.

3 part system works way better than the 2 part I used in NZ. Mixes really evenly with hardly any effort.

 

 

Super cool! Can you reuse the sand after is has been used with the resin in it? can you give an example of the sand recycling process? #thumbsup

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...