Jump to content

Chris R's various honda thread including punishing modern non os daily driver updates


chris r

Recommended Posts

  • Replies 618
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Info dump of manwell stuff while I've found it 

) gearbox from CR-V (first gen) GF-RD1 4WD. Serial number of gearbox is SBXM. To find Orthia 4WD manual gearbox impossible. There were too small amount produced.

2) Pedals from Civic 6 gen (ek) 

3) Starter from any B-series manual transmission, example DENSO (31200-P3F-J01)

4) Flywheel (22100-P75-005) with bolts (90011-PH3-000)
5) Clutch master cylinder (46920-S10-003) and clutch second cylinder (46930-SR3-013) also reservoir and pipes for fluid
6) shifting arm from CR-V, Orthia, Partner or Accord Euro R

7) clutch disk (22200-P3F-035) with clutch basket (22300-P3F-005) and bolts (90034-689-000)

8 ) engine mounts for mounting gearbox: rear (50827-S10-J00), upper (50825-S10-J01) and down (50843-S10-J00)

9) half-axel (44500-S10-000)

10) and rear t bracket gearbox (50827-S10-J00) can be used from CR-V

 

A quick look suggests crv stuff shares the same part numbers so if I grab axles/mounts/shifter/everything off the crv I should be good

  • Like 3
Link to comment
Share on other sites

  • 4 weeks later...
52 minutes ago, shrike said:

But did you let the fridge settle before you turned it on? and waiting on rear diff pics to conform AWDness :P

Yes the fridge is sitting on the back deck settling. 

Will grab diff pics tomorrow. I eyeballed it today and can confirm it exists 

  • Like 1
Link to comment
Share on other sites

4 hours ago, shrike said:

Same as the CRV drivetrain?

Yeah exactly the same as the CRV stuff, Gearbox/engine are the same too and share the same mounts so that makes stuff less difficult to get. The rear trailing arms are apparently different (as are wheel bearings after trawling the catalogues)

Link to comment
Share on other sites

21 hours ago, chris r said:

Yeah exactly the same as the CRV stuff, Gearbox/engine are the same too and share the same mounts so that makes stuff less difficult to get. The rear trailing arms are apparently different (as are wheel bearings after trawling the catalogues)

So B16/18 VTEC head/intake swap on the cards? (with ECU to suit)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...