gazguy Posted February 8, 2021 Author Share Posted February 8, 2021 I mulled over that exhsust last night and I wasn't 100% on it so I had a rethink and decided the other side would run over the top of the timing cover. And the right side would go straight out and down. It was a bit of mish getting the tubes to run parallel with both the down tube and bottom frame rails but I got there in the end. On to the other side when I get more tube. 8 Quote Link to comment Share on other sites More sharing options...
gazguy Posted February 8, 2021 Author Share Posted February 8, 2021 I found some old bends in my box and had a go at the other exhaust. I was gonna tig it together but I ran out of argon. I'm thinking of buying a 90 bend to replace the tube that runs across the timing cover so there's less welds and overall better finish 3 Quote Link to comment Share on other sites More sharing options...
gazguy Posted February 17, 2021 Author Share Posted February 17, 2021 Once I got the bends I ordered from Uniweld I slowly started piecing them together. I pretty much redid the whole top pipe with a 90° which looks so much nicer. Then I added 2 straights with a 45° at each end. To get the tubes to line up nice for welding then metal finishing I made a clamp made from some bits of 25mm angle, some round bar and 2 hose clamps 6 Quote Link to comment Share on other sites More sharing options...
gazguy Posted March 12, 2021 Author Share Posted March 12, 2021 Once i got the 45 degree bends positioned to where i wanted i set about making the tailpipes. Originally I wanted rippled pipes and tried having a bash myself with no real results to show for it as the tube was too heavy a gauge, so ive settled for just straight pipes with a flared end which i made myself by making a tapered die on the lathe at work and used my hydraulic press to put the flare in. Id used a tow ball for my 1st goes which looked not too bad but it was hard to get the tow ball to sit perfect and it would give an uneven flare. Overall im quite happy with how the exhaust has turned out, I'll sort the mounts out and fully weld it up once I redo the hardtail, its pointless doing the same job twice. 6 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.