Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 had to get the 4g11 cross member out because the mounts were offset so i sourced a 4g32 one and put it in same day got alil late and called a quits by the way here is the discussion //oldschool.co.nz/index.php?/topic/43108-exbellas-ex-lancer-bella/ Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 engine in not running but in Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 got an exhaust mocked up and welded will post a photo tomorrow got it in and wired up but alternator had a dead short and caused the fusible link to burn out which was annoying and then I replaced the alternator got it turning over Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 bang she started short lived but she started burn out a coil and the dizzy in the process so i started sourcing those two bits which I did but i need too find out what caused this issue. Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 turns out after posting and reading many forums i found i wired the stupid coil wrong my bad haha Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 got it running and found i missed the half moon seal i don't know how but i did and now i got oil all over the garage floor and that's annoying a little funny but annoying got one of them and put it in and motors running took it for a WoF she failed no shock to me but i'll post a pic of the sheet hmmm what else car is on 4g32 front struts cobra lowering springs all around and monroe gas shocks in back all sounds are wired in with a kill switch cause saves me turning off the radio just push a button so a busy week or two Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 Now you up to date with me. interior is temporarily painted and same with dash until i can get someone to recover it and dumpy welded on photo will come tomorrow probably. Got a dead short somewhere in my lighting circuit cars running which is nice but as soon as I turn the lights on then the fusible link by the battery pops Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 just a couple of photos of whats lying around my house Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 interior and my new steering wheel old one was terrible. i also did some paint today of engine parts make them look neater post picks once the are dry tidy rear door cards which was a mean find pick a part did me well for once Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 the WoF sheet well i am going to be busy today Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 just some of the painting and all of this before 10am woohoo Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 10, 2014 Author Share Posted April 10, 2014 soo just found out that the fusible link blew which means something is dead shorting now my dizzy is cooked electronic dizzys suck Quote Link to comment Share on other sites More sharing options...
Exbella Posted April 29, 2014 Author Share Posted April 29, 2014 She is fixed running and warranted and ive done some shopping too got bucket seats hydraulic hand brake cause I can vr4 motor and other bits and pieces how does one know what size intercooler to use? Other tgan that im all go Quote Link to comment Share on other sites More sharing options...
Exbella Posted May 22, 2014 Author Share Posted May 22, 2014 so this is what i've been doing nearly done rebuilding it and getting ready to put it in my lancer Quote Link to comment Share on other sites More sharing options...
Exbella Posted May 22, 2014 Author Share Posted May 22, 2014 I also have my ecu and loom stored so im happy as Quote Link to comment Share on other sites More sharing options...
Exbella Posted May 22, 2014 Author Share Posted May 22, 2014 Also just because i can Quote Link to comment Share on other sites More sharing options...
Exbella Posted May 22, 2014 Author Share Posted May 22, 2014 i built a radio as well because i needed one for those long nights got adjusties as well so ill put them in and show you all the height Quote Link to comment Share on other sites More sharing options...
Exbella Posted May 22, 2014 Author Share Posted May 22, 2014 my little not so helpful helper Quote Link to comment Share on other sites More sharing options...
Exbella Posted May 25, 2014 Author Share Posted May 25, 2014 so this happened was a pain but she is in so im happy 1 Quote Link to comment Share on other sites More sharing options...
Exbella Posted May 25, 2014 Author Share Posted May 25, 2014 it was no small feat though but i believe it will be worth it in the long run Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.