Jump to content

Ford Escort block - 1760 Kent Engine


Mk2EscortSport!

Recommended Posts

Hey Guys,

I am currently building a 1760 Ford Escort :evil: with steel Datsun crank and flat top pistions. However I know that this is pretty much pushing the limits of the block. Im sure i read somewhere that there was an escort block that was released in another country that had thicker walls?? I was looking at this one for sale on trade me (http://www.trademe.co.nz/Trade-Me-Motor ... 786366.htm), could this be what im lloking for?? If I cant find one I will not bore it out so much (but that would suck because i have all the parts for a very powerful engine.. If anyone knows the type of block with thick walls or if one even exists any info would be great! :D Cheers

Link to comment
Share on other sites

I can't remember the engine code, but your looking for a rare south African Xflow block, from all i have read they were made as a base for a Xflow diesel that never went into production and ended up being sold in late mk2 escorts as a standard 711M

*Another story is they were made with thick walls to cope with SA's crap fuels

Basically i would be VERY surprised if you find one!

That one on TM is just your standard 711 block, being from a Mexico doesnt really make it anything special. I don't know where he's getting this "offset crank" idea from either

http://www.rsownersclub.co.uk/car_info/esc1rs16mex.htm

Link to comment
Share on other sites

What bore size are you looking to go to?

Your crank etc. will not stress the block enough to cause you a problem in most cases. It is the bore size or bad balancing that promotes failure.

Spend the money crack testing and ultrasounding existing blocks that are available relatively cheaply.

T numbers and so forth are no longer as relevant with these blocks as corrosion from the water galleries has eaten most of them away if antifreeze has not been used.

Each block must be inspected individually. A 711M T1 could well be stuffed, coroded and cracked where a cooking model block that was well looked after could be mint.

True words. :D

Link to comment
Share on other sites

Well,.... hopwfully i wont need to machine the block.

This is the description from the guy I bought it from:

STEEL CRANKSHAFT TO SUIT 1600 CROSSFLOW AND LOTUS COSWORTH AND BDA ENGINES ETC.MADE FROM DATSUN L18 FORGED STEEL CRANKSHAFT ALL MACHINED FOR STD JOURNAL SIZES AND HAS NOT BEEN USED SINCE MODIFYING.STEEL FLYWHEEL IS AVAILABLE TO SUIT AT ADDITIONAL COST.

So I pressume it would just slot on in??

Link to comment
Share on other sites

No.

The block needs to be relieved.

What bore size are you looking to go to?

Your crank etc. will not stress the block enough to cause you a problem in most cases. It is the bore size or bad balancing that promotes failure.

Spend the money crack testing and ultrasounding existing blocks that are available relatively cheaply.

T numbers and so forth are no longer as relevant with these blocks as corrosion from the water galleries has eaten most of them away if antifreeze has not been used.

Each block must be inspected individually. A 711M T1 could well be stuffed, coroded and cracked where a cooking model block that was well looked after could be mint.

True words. :D

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...