Search the Community
Showing results for tags 'resistor block'.
Found 1 result
[SOLVED tl:dr Resistor block failed : but read on to see some steps on problem solving with Electronic ignition in my Hillman Avenger] So drove to work yesterday, Parked all normal (over the Saddle Road) went to go to lunch & hey that's weird Car fires but wont 'run', heaps gas & sounds like its all fine until I return the key to On position, car dies I realise it's fairly basic switching & wires but a little over my head if anyone can dumb it down for a wood worker Started with the Ign switch inspection (thought it was main fault at first as a little wiggle caused the Alt light to blink) then tried a second hand unit with exactly the same results, starts but doesn't run so I'm a bit stumped, checked fuel in line, car runs good with the key in starter position (can rev it a little bit & don't want to wreck starter etc) more pics & Diagrams & maybe I've answered own question with the manual? Ballast resistor? And I'm running Electronic ignition from a later model so other than the chances of the second ign switch having same fault (unlikely) which most obvious Sparky boi have I over looked"? Internal guts of the ign switch are fairly simple too only one contact covering 1/5 > 3/2 1 : to Starter motor 2 : Acc 3 : Dash 5: (labeled it 4 on sticker) is main feed from Battery