Search the Community

Showing results for tags '2h'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Projects
    • Projects and Build Ups
    • Project Discussion
    • Two Wheels
  • Technical
    • Tech Talk
    • Tech Articles
  • Oldschool Happenings
    • Upcoming OS Events
    • Past Events
    • Upper North Island Region
    • Lower North Island Region
    • South Island Region
    • International/Australia

Categories

There are no results to display.

Calendars

  • Community Calendar

Found 2 results

  1. So after many months of looking - including (failed) bidding on sight unseen cars 9 hours away from me, mincing around car yards and looking at more rust than I care to remember - I finally pulled the trigger and purchased one of these fine automobiles. Reasons being: - It was local in Auckland. - The Toyota tax wasn't too extreme. - It was ratty, showing it had been somewhat legitimately repaired. Anyway, what I purchased is a 1985 HJ60 high roof model, not sure which trim level but it has the 'power pack' interior with central locking, power windows and sunroof, A/C, rear passenger heater. It's powered by a 2H 3980cc straight six diesel engine and an H55F 5 speed transmission. It also has a working PTO winch on the huuuuuge front bumper. Initial impressions of the truck is just how big it is, it's massive! Especially compared to my usual modes of transport, the Austin 1300 or Nissan Sentra Sportwagon. The paint is rough but it shows where work has been done. There is filler but it is mostly fresh metal underneath. Looking up the D pillar I can see some rust at the roof seam, I've acid treated this and will address it at some point. There are also a couple of small patches of rust in the rear inner wheel arch and under the rear seat floor. Will apply wax to the body to preserve the patina. Driveline wise the P/O had the engine reconditioned (receipts provided) and the owner prior to me did the cylinder head after the HG blew between no. 2 and 3 pistons. This was caused by the head not being torqued down evenly. The front hubs were also rebuilt by him after a WoF fail on oil leaks. The gearbox is a little noisy, I believe this is the input and/or output shaft bearings. Kits for this are available ex-Australia. Probably caused by towing - it lived in the Waikato towing horse floats for a while. Have not tested the 4wd system properly yet. Anyway, overall I am stoked about my new truck! Diesel and 4wd is all new to me. Planning to daily this if practical. The conveniently most appropriate stickers applied - thanks @Archetype! Also thanks @MichaelJFox for assisting in collecting this tank. Discuss:
  2. GuyW/Aviators HJ60 Discussion

    Tell me about bolt on turbo kits and the best place to buy bulk Newtech Repairer filler here. Project: