ThePog Posted January 5, 2023 Author Share Posted January 5, 2023 Ah I didnt see that. I can confirm that I definitely think I am sufficiently competent and experienced to carry out this inspection for sure bro. 1 Quote Link to comment Share on other sites More sharing options...
Truenotch Posted January 5, 2023 Share Posted January 5, 2023 Hey @Dolan - I know you're new here, but you're meant to post in the discussion thread, not the project thread . It's OK, I've fixed it. Does burning drums with a gas plant make them work better? 1 1 Quote Link to comment Share on other sites More sharing options...
ThePog Posted January 5, 2023 Author Share Posted January 5, 2023 12 minutes ago, Truenotch said: Hey @Dolan - I know you're new here, but you're meant to post in the discussion thread, not the project thread . It's OK, I've fixed it. Does burning drums with a gas plant make them work better? I applied heat to the outside until the inside stopped smoking/burning off the gummy shit, then I put it in my lathe and ran some sandpaper over the face till it looked cleanish. Made a huge improvement. 1 Quote Link to comment Share on other sites More sharing options...
Mof Posted January 5, 2023 Share Posted January 5, 2023 51 minutes ago, Truenotch said: Does burning drums with a gas plant make them work better? It's on the back of the trans, probably oil in it 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.